La-audio SPX20 Manuel d'utilisateur télécharger pdf (Page 7)

Page 7

Plugging into the inserts jacks on the front panel breaks the signal from the

rear panel XLRs

INPUT 2 & 3

These are balanced inputs on TRS jacks - see Fig 2.6.3

For ubalanced operation wire as described above for Input 1 inserts or use

a mono jack plug.

INPUT 4,5 & 6

These are all unbalanced inputs which have RCA/phono connectors.

These are wired with the centre pin as hot (signal +) and the sleeve as

screen (signal ground).

TAPE RECORD

This is line level output of the selected input or inputs. Output level

depends on the settings of the input TRIMs and on how many inputs are

selected at the same time. If the input TRIMs are set up as described in

the 'Description of Controls' sections then the level will be approximately

0dBu.

OUTPUTS section:

SERIAL No:

230V 50Hz

FUSE T50mA

Manufactured in the UK by

LAAudio

No user serviceable parts inside

Disconnect from mains before removing cover

This equipment must be earthed

OUTPUTS

RECORD OUT

LRL

OUTPUT 1 & 2

Outputs on the SPX20 are via 1/4" TRS jacks - see Fig 2.6.3

Tip Hot Signal +

Ring Cold Signal -

Sleeve Screen Signal ground

Output amplifiers on the SPX20 are 'ground compensated balanced

impedance' type.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

La-audio SPX20 Manuel d'utilisateur Page 7